Step 1: If the surface is extremely dirty, clean it with soap & water to remove the dirt. Then using rubbing or denatured alcohol, (this is highly recommended) you will want to go over the area again. (This will remove any wax or sealers, that may be on the surface (this is very important) If alcohol is not available you can use glass cleaner.



Step 2: To temporarily hold your decal in place, in the area that you are applying it. Apply several small strips of making tape to the top of your decal & the surface.



Step 3: Using a tape measure or a straight edge ruler, line up the decal to the straightest body line or molding on the vehicle. Step back and make sure it looks the way you want it to look. Sometimes even the straightest body line doesn't always look straight. Use your best judgment.



Step 4: Once the decal is in place, where you want it. Apply a horizontal piece of masking tape (approx 2" wide) across the top of the decal. Applying half the tape on the decal & half the tape on the surface of the vehicle.

Step 4: (Option) If your decal is a lot wider (left to right) then it is tall, you can apply the masking tape down the middle. (from top to bottom)



Step 5: With the masking tape now creating a hinge, fold your decal up, folding on the hinge. Start removing the wax backing paper, starting from the top and pulling downward approx 1/2 way down.





Step 5: (Option) With the masking tape now creating a hinge, fold your decal in half, pull the backing paper away from that half of the decal & tear at the middle. (NOT TEARING THE TAPE OR DECAL)